Welcome to 16-channel Servo Debugging Board repository
Potentiometer control servo
1. Learning target
In this course, we will earn how to use Micro:bit, 16-channels servo debugging board and potentiometer module to control servo.
2. Preparation
Connect the module to Micro:bit board by expansion board, as shown below.
3.Programming method
Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package https://github.com/YahboomTechnology/Servo_16C
to programming.
Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/YahboomTechnology/Servo_16C , you can start programming.
4.Looking for blocks
The following is the location of the building blocks required for this programming.
5.Combine block
The summary program is shown below.
6. Phenomenon
After the program is downloaded successfully. Twist the potentiometer, servo S1 will turn. Press the micro:bit button A, the dot matrix screen will display 2. Twist the potentiometer, servo S2 will turn. Press the micro:bit button B, the dot matrix will display 1. Twist the potentiometer, servo S2 will turn.