Welcome to 2.4G 10-channel Controller repository
1.Introduction to Model Aircraft Remote Control
2.4G 10-Channel Remote Control
2.4G 10-Channel Remote ControlProduct ParametersFunction ButtonsDefault ChannelsSBUS ReceiverPairing StepsPWM ReceiverPairing Steps
Product Parameters
Function Buttons
Default Channels
| HT-10A Remote Controller | Default Channels: No channel mapping on the remote |
|---|---|
| CH1 | Right Joystick: Left/Right |
| CH2 | Right Joystick: Up/Down |
| CH3 | Left Joystick: Up/Down |
| CH4 | Left Joystick: Left/Right |
| CH5 | SWA Channel |
| CH6 | SWB Channel |
| CH7 | SWC Channel |
| CH8 | SWD Channel |
| CH9 | VRA Channel |
| CH10 | VRB Channel |
SBUS Receiver
| SBUS Receiver | Function |
|---|---|
| S | Signal Line (SIG) |
| + | Power Positive (VCC): 5V |
| - | Power Negative (GND) |
Pairing Steps
| SBUS Receiver LED Status | Meaning |
|---|---|
| LED Slow Flash | Device not connected |
| LED Fast Flash | Pairing mode |
| LED Solid On | Device connected |
Power on the SBUS receiver. The LED on the SBUS receiver will be in slow flash mode;
Press and hold the button on the SBUS receiver for 1 second. The LED will fast flash, indicating the SBUS receiver has entered pairing mode;
Turn on the HT-10A remote controller's power switch. On the main interface, press the "OK button" to enter settings, then use the "Up button", "Down button", "Back button", and "OK button" to navigate different options:
After successful connection, the LED on the SBUS receiver will be solid on: When connected, it cannot enter pairing mode.
Note: The HT-10A remote controller and SBUS receiver only need to be paired once. They will automatically connect on next power-on. No need to pair again!
PWM Receiver
| PWM Receiver | Pin Function |
|---|---|
| S (Signal) | SIG (Yellow) |
| + (Positive) | VCC (Red): 5V |
| - (Negative) | GND (Black) |
Pairing Steps
| PWM Receiver LED Status | Meaning |
|---|---|
| LED Slow Flash | Device not connected |
| LED Fast Flash | Pairing mode |
| LED Solid On | Device connected |
Power on the PWM receiver. The LED on the PWM receiver will be in slow flash mode;
Press and hold the button on the PWM receiver for 1 second. The LED will fast flash, indicating the PWM receiver has entered pairing mode;
Turn on the HT-10A remote controller's power switch. The HT-10A remote controller will automatically pair with the PWM receiver;
After successful pairing, the LED on the PWM receiver will be solid on: When connected, it cannot enter pairing mode.
Note: The HT-10A remote controller and PWM receiver only need to be paired once. They will automatically connect on next power-on. No need to pair again!