Welcome to Tiny:bit Robot Car repository
当製品の日本語版マニュアル資料は、こちらからご取得ください。
5.1 Advance
1.Preparation
1-1.The position of the motor on the robot car
Programming method:
Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package: https://github.com/YahboomTechnology/Tiny-bitLib to program.
Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/YahboomTechnology/Tiny-bitLib, you can program.
As shown in the figure below, the red arrow points to the Tiny-bit motor.
2.Learning goal
2-1.Learn how to use control motor graphically program building blocks
2-2.In this lesson, we will make robot car advance.
3.Search for block
The following is the location of the building blocks required for this programming.
4.Combine block
The summary program is shown below:
5.Experimental phenomena
After the program is downloaded, we can see that the robot car will advance.