Welcome to World of Module Sensor Kit repository
2.Light up a RGB
1. Learning target
In this course, we will learn how to use Micro:bit and RGB light module to achieve light up a RGB.
2. Preparation
Connect the module to Micro:bit board by expansion board, as shown below.
!Tips: Button connect to P1 pin of Micro:bit in this course.
3.Programming method
Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package https://github.com/YahboomTechnology/Module-World to program.
Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/YahboomTechnology/Module-World , you can start programming.
4.Looking for blocks
The following is the location of the building blocks required for this programming.
5.Combine block
The summary program is shown below.
6.Experimental phenomena
After the program is downloaded successfully, RGB light become red.
Changing the corresponding value will get a different color.
Green light:
Blue light:
White light:
Close RGB light:
