Welcome to World of Module Sensor Kit repository

1. Learning target

In this course, we will earn how to use Micro:bit, RGB light module and rocker module to realize gesture control light.

2. Preparation

Connect the module to Micro:bit board by Micro:bit expansion board, as shown below.

3.Programming method

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package https://github.com/YahboomTechnology/Module-World to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/YahboomTechnology/Module-World , you can start programming.

4.Looking for blocks

The following is the location of the building blocks required for this programming. 

5.Combine block

The summary program is shown below.

6. Phenomenon

After the program is downloaded successfully. We can control the RGB light by shaking the rocker. If the rocker moves to the left-most in the X direction, the RGB light become red;

If the rocker moves to the right-most in the X direction, the RGB light become green;

If the rocker moves to the up-most in the Y direction, the RGB light become blue;

If the rocker moves to the down-most in the Y direction, the RGB light become white.