Welcome to World of Module Sensor Kit repository

1. Learning target

In this course, we will earn how to use Micro:bit, RGB light module and photosensitive module to make a emergency light.

2. Preparation

Connect the module to Micro:bit board by expansion board, as shown below.

3.Programming method

Mode 1 online programming: First, we need to connect the micro:bit to the computer by USB cable. The computer will pop up a USB flash drive and click on the URL in the USB flash drive: http://microbit.org/ to enter the programming interface. Add the Yahboom package https://github.com/YahboomTechnology/Module-World to program.

Mode 2 offline programming: We need to open the offline programming software. After the installation is complete, enter the programming interface, click【New Project】, add Yahboom package: https://github.com/YahboomTechnology/Module-World , you can start programming.

4.Looking for blocks

The following is the location of the building blocks required for this programming. 

5.Combine block

The summary program is shown below.

6. Phenomenon

After the program is downloaded successfully. When we block the photosensitive module with our hands, the RGB light is on, otherwise the light is off.