MoveIt Collision Detection

1. Usage Environment

Board: Jetson Orin Nano/Nx

ROS2: Humble

If you are using a Jetson Nano development board, you will need to enter the commands from the tutorial into the accompanying virtual machine to run this function.

2. Drive Real Robot

Driving the real robot is done by subscribing to MoveIt2's /joint_states topic and converting the robotic arm's joint state information into control of the real robotic arm.

Note: Since the real robotic arm does not have obstacle avoidance functionality, some poses may collide with obstacles; therefore, try to make the planned robotic arm motions reasonable and avoid positions with obstacles

(It is recommended to use preset poses for driving the real robot demonstration)

The Jetson Nano mainboard requires multi-device communication configuration. The robotic arm and the virtual machine need to be on the same network, and the ros_domain_id of the virtual machine must match the ros_domain_id in the Docker container. (The factory configuration already ensures that both ros_domain_ids are the same; you only need to ensure that the virtual machine and the robotic arm are on the same network.)

2.1. Start Real Robot

Without driving the real robot, perform simulation demonstration of robotic arm motion in MoveIt:

#Jetson Nano users need to run this command in a virtual machine, while Orin users can run this command directly on the mainboard.
ros2 run dofbot_pro_driver dofbot_pro_driver

2.2. Launch MoveIt2

#Jetson Nano users need to run this command in a virtual machine, while Orin users can run this command directly on the mainboard.
ros2 launch dofbot_pro_moveit demo.launch.py

3. Collision Detection

After the program runs, RViz2 will add a rectangular obstacle next to the robotic arm. The robotic arm will plan to the program's target position, and the entire planning and execution process will automatically avoid the obstacle.

3.1. Visualization

Before running the launch command, you need to add the MarkerArray plugin in RViz2 to display the planned path: MarkerArray needs to select the arm_group topic

3.2. Launch Command

The robotic arm needs to be successfully loaded in MoveIt and You can start planning now! appears before running the following command: The robotic arm will automatically avoid the rectangular obstacle and plan and execute to the specified position

#Jetson Nano users need to run this command in a virtual machine, while Orin users can run this command directly on the mainboard.
ros2 run dofbot_pro_moveit obstacle_avoidance