Webpage Image Transmission Control（CM5）

The functions of the RiderPi screen are shown in the figure:

Keys A and B are for left and right selection, key C is for exit, and key D is for confirmation.

1. Enter network configuration mode and connect the RiderPi to the same local area network.

Specific steps are as follows:

I. First, enter the network configuration mode of the example program.

II. Press key D to enter network configuration.

III. Open the XGO or XGOBOT interface, select the network configuration mode, enter the Wi-Fi network your phone can find into the app, and click to generate a QR code.

For example: If your phone finds a Wi-Fi network named "Hello" with the password "12345678", enter the information in the app as shown and click to generate a QR code.

IV. Scan the generated QR code with the RiderPi. After a successful scan, you will connect to the Wi-Fi network specified in the QR code, and then the page will automatically exit.

V. Press button C on the screen to exit to image transmission mode.

2. Image Transmission Remote Control Steps

I. Select image transmission mode and press button D to enter.

II. Open your computer/mobile phone's browser (computer browser recommended). Enter the RiderPi's IP address and port number. For example, in the image above, the RiderPi's IP address is 192.168.11.83, and the port number is 8080. The output will look like this:

Press Enter to enter image transmission mode.