Welcome to Jetson Orin NANO Developer Kit repository
03. System Update Notes
Orin Nano Installation and Update Notes
Users who purchased after October 17, 2025 can skip this tutorial; customers who purchased before October 17, 2025 must pay special attention:
If you need to run the upgrade command or click the pop-up window to update the system, you must execute the following commands before running it, otherwise the system will not boot after the update.
sudo apt updatesudo apt install cpio
Run upgrade after running the above commands.
xxxxxxxxxxsudo apt upgradesudo apt-get upgradeIf you update the system using the desktop pop-up prompt, after clicking install, you need to run the following commands while the system has not been shut down and restarted; otherwise, the system will not boot after restarting.
xxxxxxxxxxsudo apt updatesudo apt install cpiosudo apt upgradeSolution to Boot Failure After System Update:
If you want to continue using our image, first refer to item ①, prepare a solid-state drive enclosure yourself, and re-write the solid-state image. If the system still fails to boot after re-writing the solid-state image, then refer to item ② and write the super bootloader. Finally, check whether the system boots.
If you do not use our image, you can refer to the following tutorial to write the official clean image. However, the clean image does not contain any environment, so our tutorials cannot be used directly.