Welcome to Jetson Orin NANO Developer Kit repository
10.Write the system onto your own SSD
10. Writing a Self-Provided SSD System
10. Writing a Self-Provided SSD System1. Preparation Before Writing2. Writing the Yahboom Factory System1. Writing the SUPER Bootloader2. Writing the Yahboom Factory Image to the SSD2.1. Formatting the SSD1. Downloading DiskGenius2. Using DiskGenius2.1. Deleting the Partition2.2. Creating a New Partition2.2. Writing the Image to the SSD1. Installing Win32DiskImager2. Using Win32DiskImager
1. Preparation Before Writing
A self-provided SSD only supports M.2 Key M and M.2 Key B+M interface SSD storage devices, and is not compatible with M.2 Key B interface SSD storage devices. The storage capacity must not be less than 256G.

The recommended size is 2280, 22X80(mm)

2. Writing the Yahboom Factory System
Notes on using the Yahboom factory image: two conditions must be met for the mainboard to boot, one is that the super bootloader is written, and the other is that the Yahboom factory image is written to the SSD. Both are indispensable, otherwise the system cannot power on. (Must Read)
1. Writing the SUPER Bootloader
Note: If the SUB version package was purchased, the super bootloader has already been written at the factory, so there is no need to write the super bootloader, and this step can be skipped.
To write the bootloader, refer directly to the tutorial 【07. Writing the SUPER Bootloader (Must Read)】.
2. Writing the Yahboom Factory Image to the SSD
Before writing, install the SSD into the SSD enclosure.

2.1. Formatting the SSD
1. Downloading DiskGenius
Download URL: https://www.diskgenius.cn/

Decompress the downloaded archive to open and use DiskGenius.exe:

2. Using DiskGenius
2.1. Deleting the Partition
Deleting a partition will clear the disk data. Confirm that the drive letter is the disk to be formatted before confirming the operation: you can judge by the disk size and the drive letter newly added after the disk is connected




2.2. Creating a New Partition
Partition the SSD into exFAT format.
Select the drive letter corresponding to the SSD, then click Quick Partition:

Partition options: check the items as shown in the figure below


2.2. Writing the Image to the SSD
The factory image system in the materials needs to be downloaded and decompressed locally in advance.
1. Installing Win32DiskImager
Download URL: https://sourceforge.net/projects/win32diskimager/

Open the win32diskimager-1.0.0-install.exe installation package as an administrator and accept the agreement:

Installation location: The default location is recommended

Installation options:


Start the installation:

Complete the installation:

2. Using Win32DiskImager
①: Select the factory image file (*.img) in the materials
②: Select the drive letter corresponding to the SSD
③: Write the factory image to the SSD

Confirm writing to the system:

Wait for the system to be written successfully:


After the system writing is complete, close the program, eject the SSD, and install the SSD into the mainboard on which the SUPER bootloader has been written. The system can be powered on after power is connected.